DOWNLOADS

  • Specification Sheet
  • User's Manual
  • Technical Notes
  • Software

Contact factory

View >

Related Products

  • UX400

16G Fibre Channel
Module

UX400-16G

Offers multi-rate wire-speed traffic generation at all commercially available Fibre Channel rates with FC-2 BERT for link integrity testing. Also supports latency and buffer-to-buffer credit measurements for SAN installation, commissioning and troubleshooting tasks.

MODULE HIGHLIGHTS

General

  • Single-slot test module
  • Dual SFP+ optical ports
  • Up to two coupled or independent tests per module
  • SCPI-based remote control and scripting commands

Fibre Channel

  • Full line-rate traffic generation/analysis at 1.0625, 2.125, 4.25, 8.5, 10.52 and 14.025 Gbps
  • Traffic generation from 0.01% to 100%
  • FC-1 and FC-2 BERT, and Throughput testing
  • RFC2544 Verification – Throughput, Latency, Frame Loss, Burstability (Back-to-Back Frames)
  • Performance Measurements – Delay, Packet Jitter, Sequencing
  • Frame Length configuration up to 2148 bytes
  • Traffic shaping: Constant, Ramp, and Burst profiles
  • FC-1 Test Patterns: CJTPAT, CRPAT, CSPAT
  • FC-2 Test Patterns: ITU-T PRBS, 211-1 , 215-1, 223-1, 231-1
  • FC-2 Frame Header configuration
  • Flow Control Support with configurable buffer-to-buffer credits
  • Primitive Sequence Protocol support, link initialization, link reset, link failure
  • Layer 1 and 2 Loopbacks including FC-2 Smart Loop mode
  • Packet Capture and decode of error events with selectable triggers
  • Automated Test Reports and Event Log based on Errors and Alarms
  • Service Disruption Measurement