The VeEX™ MX product series offer a complete test solution for Metro Ethernet network installation and maintenance. Powerful features such as symmetrical and asymmetrical RFC2544 conformance testing, Multiple independent stream generation, Stacked VLAN (Q-in-Q) and MPLS tagging, and Dual Port Traffic Generation/Analysis are available at 10GBase-R, 1000Base-X and 10/100/1000Base-T test interfaces. Fiber Channel testing at 1Gbps and 2Gbps rates is supported on select models.
VeEX™ MLX100 Metro Loopback Expert is an intelligent Ethernet loopback device developed as a perfect companion to the MX100+, MX120+, MX300, and TX300 products. Loopback control can be performed in-band or via the built-in 10/100Base-T Ethernet port via an Internet connection. When paired with the compatible MX/TX series, the MLX100 is the industry’s most costeffective solution for point-to-point Service Level Agreement (SLA) verification and end-to-end performance testing.
Low cost Ethernet loopback device for testing end-to-end network performance when paired with MX100+, MX120+, MX300, TX300, or 3rd party Ethernet testers
Ideal for testing transparent, switched, routed, and next generation carrier grade Ethernet networks
10/100/1000Base-T Electrical port (IEEE802.3), RJ45
1000Base-X Optical port supporting hot swappable, MSA compliant SFP transceivers
BERT, RFC2544 and Throughput application eliminating the need for an expensive remote test partner
Smart Loop mode for Layer 1, Layer 2, Layer 3, and Layer 4
Intelligent device Discovery mode
In-band loopback control; accepts loopback commands from MX100+, MX120+, MX300, or TX300
Out-of-band operation via 10/100Base-T Ethernet management port and ReVeal software
Activate a loopback profile from a remote location
Default loopback profile storage for fast and easy loopbackready boot-up
RS232 supervisory port to configure IP address
Remote control capability and loopback profile creation/upload through ReVeal PC software
Layer 1, Layer 2, Layer 3, and Layer 4 modes are available for looping back test traffic
Layer 1: loops back all incoming traffic
Layer 2: all incoming unicast traffic is looped back with MAC source and destination addresses swapped
Layer 3: all incoming unicast traffic is looped back with MAC and IP source and destination addresses swapped
Layer 4: all incoming unicast traffic is looped back with MAC, IP, and UDP/TCP ports swapped
Products
