The VeEX™ MX product series offer a complete test solution for Metro Ethernet network installation and maintenance. Powerful features such as symmetrical and asymmetrical RFC2544 conformance testing, Multiple independent stream generation, Stacked VLAN (Q-in-Q) and MPLS tagging, and Dual Port Traffic Generation/Analysis are available at 10GBase-R, 1000Base-X and 10/100/1000Base-T test interfaces. Fiber Channel testing at 1Gbps and 2Gbps rates is supported on select models.
VeEX™ MLX300 Metro Loopback Expert is an intelligent 10GE loopback device developed as a perfect companion to VeEX 10GE
testers. Loopback control can be performed in-band over the fiber interface or via the built-in 10/100Base-T Ethernet port via an Internet connection. Field interchangeable XFP transceivers support various wavelengths and power level requirements. Paired with the MX300/TX300 handheld tester, the MLX300 is the industry’s most cost-effective solution for point-to-point Service Level Agreement (SLA) verification and end-to-end performance testing.
Cost-effective 10GE loopback device for testing end-to-end network performance when paired with companion tester
Ideal for testing transparent, switched, routed, and next generation carrier grade Ethernet networks
10GE LAN/WAN XFP support
BERT, RFC2544 and Throughput application eliminating the need for an expensive remote test partner
Smart Loop mode for Layer 1, Layer 2, Layer 3, and Layer 4
Out-of-band operation via 10/100Base-T Ethernet management port and ReVeal software
Activate a loopback profile from a remote location
Default loopback profile storage for fast and easy loopbackready boot-up
In-band control is supported for all VeEX Ethernet products; Compatible with MX300/TX300 and MX100+/MX120+ loopback control for end-to-end testing from the 10GE Core network to a 1GE drop on the Metro or Access network
RS232 supervisory port to configure IP address
Remote control capability and loopback profile creation/upload through ReVeal PC software
Layer 1, Layer 2, Layer 3, and Layer 4 modes are available for looping back test traffic
Layer 1: loops back all incoming traffic
Layer 2: all incoming unicast traffic is looped back with MAC source and destination addresses swapped
Layer 3: all incoming unicast traffic is looped back with MAC and IP source and destination addresses swapped
Layer 4: all incoming unicast traffic is looped back with MAC, IP, and UDP/TCP ports swapped
Products
